I designed and built my 3 story 3 car gar.
Car siding installation ceiling.
In fact it s almost always the case with the very last board.
1 cut siding to length with a chop saw power miter saw 2 hold against wall or ceiling.
The material cannot split or crack when you install a nail to hold up the siding.
Space the end 1 4 inch from the wall at the corner.
Press tongue of one board into groove of next.
But it can also happen at shiplap ceiling protrusions or even at projecting inside corners.
Position a full length lank of siding spaced 1 4 inch from the wall with the tongue side out and the groove toward the wall.
As most of my videos are rambling about what i ve done this one is actually a how to.
On any installation you ll have times when you can t fit the groove in the previous tongue and seat the board.
Drive a test nail or two through the material if necessary to ensure it will hold up the siding.
Inspect the ceiling surface to make sure it is solid enough to support nails.
4 putty and paint if desired.
Start installation along the longest wall in the space.